New to this

mialliw · Post by **mialliw** » Sat Dec 18, 2004 4:39 am

Well i have read the manuel but still dunno how to do this. THe first time i ran wineq i was shocked at how i can run 2 eq games and not get any lag... NOW the only issue i have is that the windows are to small to see what i am doing. ATM tey are set to normal but with both eq's running they take the top quarter of my screen and that is it. i like how they shared the screen by splitting in the middle but i want them to run to the full length of the screen. so what i am asking is how and where and what setting do i sue to change it?

Post by **Lax** » Sat Dec 18, 2004 10:43 am

WinEQ adds custom resolutions to the in-game list. Inside the game, hit Alt+O, click the Display tab, then click Video Modes. In the list will be modes you can use for full split-screen. For example, if your display resolution is 1600x1200, you want to pick 800x1200 if you want side-by-side, or 1600x600 for one on top and one on bottom. If your display resolution is 1024x768 or smaller, you will not see split-screen modes without increasing the resolution (this is a limitation of EQ). I am assuming that your display resolution is 1280x### or larger, so you should have no problem finding them

mialliw · Post by **mialliw** » Sat Dec 18, 2004 12:23 pm

what i am wanting to do is basicly strath the screen out.. the resolution is fine. i just want to stretch it out from the top of my screen to the bottom.. insteas fo getting like a 1/4 of the screen i can get a full screen of one instance and a full screen of the other while they split the screen togther in other word shave them side by side but of the full length of the monitor

Post by **Lax** » Sat Dec 18, 2004 12:28 pm

For example, if your display resolution is 1600x1200, you want to pick 800x1200 if you want side-by-side

In game, pick the resolution that is half the width of your monitor's resolution.