Lavish.dll mismatch with Fury causing EQ to fail in WinEQ2

Aala · Post by **Aala** » Sat Aug 26, 2006 3:48 am

I've discovered that if I fire up Fury after I launch WinEQ2, if I then try to create a new EQ session, it fails with the following error box:

eqgame.exe - Entry Point Not Found

X The procedure entry point Func16 could not be located in the dynamic link library Lavish.dll

This appears to be a version mismatch -- Fury uses a different (older) version of Lavish.dll than WinEQ2, and even if I copy in the version of Lavish.dll from the WinEQ2 directory to the Fury directory, it promptly re-patches over it.

The only work-around I've found is to try and run WinEQ2 again, at which point it says it detected it was already running, and exits -- but now the right DLL is in place and I can launch EQ.

Post by **Lax** » Sat Aug 26, 2006 11:11 am

Yeah, known issue. Just launch WinEQ 2 first -- Fury is going to be merged into WinEQ 2's successor product, so it hasn't been updated in a while =/

Post by **Lax** » Sat Aug 26, 2006 11:42 am

I updated the Fury patch as of now to fix this for you. Have fun

Aala · Post by **Aala** » Sat Aug 26, 2006 4:17 pm

Thanks