Difference between revisions of "ISUplink:Relay (Command)"
(→Note) |
|||
| Line 13: | Line 13: | ||
*Relay is1 "Press 1" | *Relay is1 "Press 1" | ||
: From the uplink | : From the uplink | ||
| − | * | + | *Relay is1 "Press Alt+F1" |
: From a session | : From a session | ||
*Relay all -echo "Hi" | *Relay all -echo "Hi" | ||
*Relay "all local" -echo "Hi" | *Relay "all local" -echo "Hi" | ||
| − | |||
: Relaying events | : Relaying events | ||
| − | * | + | *Relay all -event EVENT_NAME Param1 |
| − | |||
== See Also == | == See Also == | ||
Revision as of 17:00, 13 December 2009
Contents
Syntax
relay <uplink name|session name|all|all local> [-echo|-event <name>|-noredirect] <message|command>
Description
Relays a command to a given session. This is asynchronous -- the command is not guaranteed to have executed in the given session by the time this command completes. If "all" is used, the command is broadcast to all sessions (including remote). If "all local" is used, the command is broadcast to all local sessions.
Note
From Lax: When you relay, the output of the command is sent to the sender, not displayed on the remote session. The -noredirect switch makes it so the output is displayed on the remote session
The uplink's name, is the same as the system-name. The system-name can be read with ${SettingXML[InnerSpace.XML].Set[Remote].GetString[Name].Escape}
Examples
- Relay is1 "Press 1"
- From the uplink
- Relay is1 "Press Alt+F1"
- From a session
- Relay all -echo "Hi"
- Relay "all local" -echo "Hi"
- Relaying events
- Relay all -event EVENT_NAME Param1
